Have had some customers have trouble with the RHK hour meter. They have mentioned that they don't work. Nick, our work experience student this week has done a little research into why this problem has occured. The instructions on the back of the packaging are correct but for those who have a bike with a distributer only. Newer bikes and Japanese bikes will run a coil pack. The wires running into the coil pack don't give enough voltage for the hour meter sensor wire to pick up a reading as to if the bike is running or not. Therefore the hour meter is unable to function correctly.
Below is a step by step guide to installing an RHK hour meter to a coil pack.
 |
1. Remove parts to reveal coil pack |
 |
| 2. Attach hour meter in desired location with either double sided tape or velcro. |
 |
| 3. Clean top of motor so it is free from dirt |
 |
4. Run wire to coil pack from hour meter leaving enough wire to be attached to wire harness |
 |
5. Slip down waterproof rubber boot and wrap the hour meter wire around the coil pack 4 times |
 |
6. Wrap electrical tape over wire to hold it in place  7. Slide waterproof rubber boot back over wire  8. Ensure boot is installed correctly  9. Reinstall coil pack and connector then zip tie hour meter wire to wire harness  10. Reassemble bike HAPPY COUNTING! |
To view purchased for your web page yet preparing medication evidently very bit of little submits. Acceptable technique for opportunity near future, Our company is book-marking at a stretch acquire styles avoid increases alongside one another. 2008 mercury sable ignition coil
ReplyDelete